Schematics Help?...

I'm not sure if Gibson still used 50s wiring in 59 or not.

If you follow the Duncan plan, it'll work, but it will be modern wiring.
The one in my pic differs in how the tone pot connects.


EG

...so the tone pot connects to the volume pot via the cap, and that main wire there, on the middle prong? Then it jumps on top for the ground, and then off to the input jack, correct?...
 
This shows the difference in how the tone pot connects in modern vs 50s.

http://www.blueskillet.com/Gibson_Mods.htm

There's honestly not that much difference between the two. The 50s wiring keeps highs from bleeding off as you turn volume down. The difference is subtle at best. The downside to it is that the tone pot is interactive with volume and turning tone way down will cause a volume drop.

EG
 
This will do the trick...

basicwiringforcoda.jpg


Don't forget to ground the bridge...
 
By the way, this is looking down at the face of the guitar, so you are looking at the knob side of the pots...
 
This shows the difference in how the tone pot connects in modern vs 50s.

http://www.blueskillet.com/Gibson_Mods.htm

There's honestly not that much difference between the two. The 50s wiring keeps highs from bleeding off as you turn volume down. The difference is subtle at best. The downside to it is that the tone pot is interactive with volume and turning tone way down will cause a volume drop.

EG

Yep, which is why I always take the tone circuit off the output side to retain the highs...
 
...ok...this is how I think it is supposed to be, judging by whats been posted here, and a little guitar wiring csi...

21mgr5l.png


V and T and C = volume and tone pots and the Cap
red= ground
grey= the ground sheathed lead
blue= the prong that looks like it was cut off

...does that make sense?...
 
...so I wired the guitar as I diagramed...and it works...kinda. I only get sound when I touch the ground sheathing...so how do I remedy that?...
 
...so I wired the guitar as I diagramed...and it works...kinda. I only get sound when I touch the ground sheathing...so how do I remedy that?...

If you wired it like you showed, it will not be right... Look at my diagram.. The volume is on the right, and is from the perspective of looking down at the face of the guitar... Notice that the hot from the pickup goes to one outer lead, and the other outer tab is grounded... The center terminal goes to the output jack... Your tone circuit looks OK, as it can either come off the pickup hot side, or off the center output terminal... Don't forget to ground the bridge, and don't forget to ground the pots to each other... Also, don't forget the ground for the output jack...
 
If you wired it like you showed, it will not be right... Look at my diagram.. The volume is on the right, and is from the perspective of looking down at the face of the guitar... Notice that the hot from the pickup goes to one outer lead, and the other outer tab is grounded... The center terminal goes to the output jack... Your tone circuit looks OK, as it can either come off the pickup hot side, or off the center output terminal... Don't forget to ground the bridge, and don't forget to ground the pots to each other... Also, don't forget the ground for the output jack...

...yea, I beginning to think this is out of my league. I have no idea how to get a ground to the bridge, nor the input. Not to mention that the bit of string that I tied to the tone pot for ease of replacement just broke :embarrassed:...
 
Back
Top